Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R920 System Owner's Manual

PDF

Removing The Network Daughter Card

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. Open the system.
  3. Locate and remove the NDC riser (I/O riser 1).
    The NDC is on riser 1.
  4. Using a #2 Phillips screwdriver, loosen the two captive screws that secure the network daughter card to the IO riser card.
  5. Hold the network daughter card by the edges on either side of the touch point and lift to remove it from the connector on the IO riser card.
  6. Slide the network daughter card away from the bracket until the NIC connectors are clear of the slot.
Figure 1. Removing and Installing the Network Daughter Card
The figure shows removing and installing the Network Daughter Card.
  1. NDC panel
  2. I/O riser card
  3. NDC connector on the I/O riser card
  4. screw (2)
  5. network daughter card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\