- Notes, Cautions, and Warnings
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade
Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- Hard Drives/SSDs
- Hard Drive/SSD Backplane
- I/O Module Mezzanine Cards
- Network Daughter Card/LOM Riser Card
- Management Riser Card
- SD vFlash Card
- Processor/DIMM Blank
- Processors
- System Board
- System Memory
- NVRAM Backup Battery
- Storage Controller Card/PCIe Extender Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Dell PowerEdge M820 Systems Owner's Manual
Mezzanine Card Installation Guidelines
The blade
supports up to four mezzanine cards:
- Mezzanine card slot C supports Fabric C. This card must match the fabric type of I/O modules installed in I/O module bays C1 and C2.
- Mezzanine card slot B supports Fabric B. This card must match the fabric type of I/O modules installed in I/O module bays B1 and B2.
The blade supports SFF mezzanine cards. x8 PCIe Gen 3 cards are supported.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\